Stanley Emergency Rescue Hardware Set
Rescue Hardware is for a variety of door applications including patient rooms in hospitals, institutions, and convalescent homes to private baths. Permits doors to normally swing into the bath, thus saving space, yet swing out into the bedroom, incase of emergency when a patient is trapped inside.
This Stanley hospital rescue hardware set is composed of a the following items:
Stanley DAP-3 (Double acting pivot), ES-1 (Emergency Door Stop), and DSL-2 (Double Lipped Strike).
What's included from MDI Supply with the Rescue Hardware Set?
» One (01) DAP-3 Double Acting Pivot
» One (01) ES-1 Emergency Door Stop
» One (01) DLS-2 Double Lip Strike for center hung doors (for 5 3/4" Jamb Depth Frames).
Rescue Hardware Item Details:
Double Acting Pivot
DAP–3 – (ANSI A2742) – Brass and mallable iron – standard finishes
Heavy duty pivot assembly for commercial double acting interior doors of average frequency use, weighing up to 135 lbs. (61 Kg) and not exceeding 3' (91mm) in width
» For 1 3/8" (35 mm) and 13/4" (44mm) thick doors
» Header plate has a walking beam design to simplify door installation
» Extra heavy 1/4" (6.35mm) thick solid brass frame plates
» Oil impregnated bronze bearing in top door plate
» Smooth acting ball bearing assembly in bottom door plate
» For door undercuts in 1/16" (1.6mm) increments from 3/4" (19mm) to 1" (25mm)
» Bottom bracket is frame mounted and must be floor supported
» The recommended positioning of the door is to inset it 1/8" (3.2 mm) from the bathroom face of the frame
Emergency Door Stop
ES–1 – (ANSI A1882) – Extruded and cast brass – standard finishes
» For converting double acting doors to single acting doors
» Emergency release allows door to swing open in opposite direction to reach ill patients who fall and block normalpath of door
» Stop release resets automatically. Spring action stop, with finger-tip release, using pullman-type latch bolt withrubber bumper insert
» Refer to template for door clearance
Double Lipped Strikes
DLS–2 – For center hung doors – Brass – standard finishes
» Allows center hung doors to be opened in both directions without damage to frame
» For 5 3/4" (146mm) cased opening (trimmed opening) profile.
» Latch bolt cut out is 1 1/4" x 11/16" ( 32mm x 17.5mm) ANSI standard for heavy-duty bored type locks. For mortise locks consult MDI Supply.